#642 “CRYSTAL” CLEAR ROOF TILE SEALER

• Long Lasting Protection
• Resistant to UV Rays
• Extends the Life of your Tile Roof
• Built in Fungicides and Algaecides
• Provides Alkali Resistance
• Natural, Transparent Finish when Dry

Surface must be clean and dry, free of moisture on the surface. Pressure wash roof thoroughly to remove as much dust, dirt and debris as possible. Let surface dry completely before application.

#642 “Crystal” Clear Tile Sealer can be applied to a dry surface. Shake or stir #642 “Crystal” Clear Tile Sealer thoroughly before application to achieve a uniform consistency. Apply by sprayer, brush or roller. Use product when outside temperatures is 50°F or higher. DO NOT HEAT CONTAINER. DO NOT THIN.

A application rate of 200 - 300 sq. ft. per gallon is required. The application rate will vary due to surface porosity. Allow the first coat to dry a minimum of 3 hours. For best results a second coat can be applied at the rate of 350 to 400 sq. ft. per gallon.

DO NOT APPLY IF TEMPERATURE IS BELOW 50°F or above 110°F. DO NOT APPLY IF THERE IS A THREAT OF RAIN OR DEW WITHIN 48-72 HOURS. Be sure the lid is tight and the pail is
secured when transporting this product. Do not allow pail to tumble as this may loosen the lid and allow leakage or spillage to occur. DO NOT ALLOW PRODUCT TO FREEZE. Do not heat container or store at temperatures greater than 120°F. This coating is not recommended for areas with inadequate drainage (ponding water), over gravel, over walking decks, or old roofs that are too brittle and dry. DO NOT APPLY TO FLAT SURFACES WITH POOR DRAINAGE OR WHERE PONDING WATER WILL EXIST.

If coating has dried clean tools with mineral spirits or paint thinner. If coating is still wet, clean up with warm soapy water.

Available in 1-gallon pails, 5-gallon pails and 55-gallon drums.

D.O.T. Classification: Roof Coating, Not Regulated NFMC #170080