#997 MULTIPURPOSE PRIMER

• Adhesion Promoting
• Single Component Universal Primer for Acrylic and Silicone
• Rust Inhibiting Formula over Metal
• Fast Dry
• Low VOC
• Easy to Spray, Roll or Brush On

#997 should not be applied to wet, dusty, oily, mildewed, heavily chalked, blistered or otherwise structurally unsound surfaces. Do not apply #997 over silicone. Once cured, the #997 will have a slightly tacky finish to the touch. It is advisable to wear some form of boot/shoe cover when walking on the finished coating while applying the topcoat.

All surfaces to be coated must be clean, dry, and paintable. It may be necessary to power wash enhance adhesion. See application specification for more details.

For ideal drying conditions, apply on warm, sunny days, preferably in the morning hours to provide maximum dry time. #997 can be applied to a dry surface. Water must be swept out of all puddles prior to application of #997. Stir thoroughly before application to achieve a uniform consistency. Apply with a brush, heavy-duty paint roller, or heavy-duty spray equipment. Under normal conditions, #997 will dry in 2 – 4 hours. Relative humidity and temperature will directly affect drying time. Avoid over application.

#997 can be applied by brush, roller or spray.

Apply at a rate of 1.0 gallon per 100 sq. feet per coat dependent upon roof porosity.

DO NOT APPLY IF TEMPERATURE IS BELOW 50° F OR ABOVE 110°F. DO NOT APPLY IF THERE IS A THREAT OF RAIN OR DEW WITHIN 48–72 HOURS. DO NOT ALLOW TO FREEZE. DO NOT THIN. DO NOT HEAT CONTAINER or store at temperatures greater than 120°F. Be sure the lid is tight, and the pail is secured when transporting this product. Do not allow pail to tumble as this may loosen the lid and allow leakage or spillage to occur.

Clean wet coating from hands and tools with soap and water. Dried coating on tools can be cleaned with mineral spirits or paint thinner.

Available in 5-gallon pails and 55-gallon drums.

D.O.T. Classification: Roof Coating, Not Regulated NFMC #170080